
22.102
Command Line Interface Reference InForm OS Version 2.2.4
■ Rate. Data transfer rate (bitrate) for the Remote Copy interface.
■ Type. Indicates the port connection type.
◆ rcip. Port is used for Remote Copy over IP (RCIP).
The following example displays information about RCIP ports:
The columns in the previous example are identified as follows:
■ N:S:P. The physical position of the port, in the syntax node:slot:port.
■ State. State of the port.
◆ ready. The port is online and ready for use.
◆ loss_sync. The port is not physically connected to anything.
◆ config_wait. Firmware has yet to be initialized.
◆ login_wait. Fibre Channel adapter is attempting port and process logins with all loop
ports.
◆ error. Fibre Channel adapter has experienced an unrecoverable error.
◆ non_participate. Port is logically isolated from the Fibre Channel loop.
◆ offline. The port is offline.
■ HwAddr. A unique identifier of the port hardware used for Remote Copy connection. For an
RCIP port, it is the MAC address of the port.
■ IPAddr. The IP address of the Remote Copy interface.
■ Netmask. Netmask for the Ethernet port.
■ Gateway. Gateway address for the Remote Copy interface.
■ MTU. Maximum Transfer Unit (MTU) size for the specified Remote Copy interface (default is
1500). The largest supported value is 9000 and the smallest is 100.
cli% showport -rcip
N:S:P State ---HwAddr--- IPAddr Netmask Gateway MTU Rate Duplex AutoNeg
0:1:1 offline 000423C21B72 - - - - n/a n/a n/a
0:1:1 offline 000423C21B73 - - - - n/a n/a n/a
1:2:1 offline 000423ADE95E - - - - n/a n/a n/a
1:2:1 offline 000423ADE95F - - - - n/a n/a n/a
Kommentare zu diesen Handbüchern