Seagate ST3390N Installationsanleitung PDF herunterladen (Seite 459)

100

101

CSQI, CSQO, and call register settings D-5

CSQI/CSQO

Standard 1.0 Modular Option EC Installation and Maintenance Guide November 1999

CSQI/CSQO

Introduction

The typical settings for CSQI and CSQO are two times the

number of Voice Mail agents, not to exceed 25 percent of the

call registers, or a maximum of 255 each. However, when the

“2 × the voice mail agent” method is used, there may not be

enough call registers to support the needs of Meridian Mail or

the PBX. This is especially true if the site has frequent use of

large distribution lists, or if broadcast messages are sent

frequently.

Also, the practice of setting the numbers for CSQI and CSQO

up to 255, and the NCR to approximately 4 × that (1024),

without doing any calculations, means that the Meridian 1 or

SL1 system may not be engineered properly.

Correcting delayed or

undelivered MWI

To correct the problem causing delayed or undelivered message

waiting indicator (MWI), follow these steps.

Step Action

1 Set the NCR according to “NCR formulas” on page D-3.

2 Determine the potential number of registers:

a. Subtract 3000 words from the free UDATA to allow for

incidental usage.

b. Divide the remainder of the free UDATA by the number of

words per call register required for the specific PBX software

release. This will give the value, for additional NCR, that can

be added to the system. See the following table for the

appropriate number of words per call register:

Number of words per call register by release

Release Words per call register

19 103

20.19 158

20.22 and later 161

21 165

1 2 ... 454 455 456 457 458 459 460 461 462 463 464 ... 467 468

Kommentare zu diesen Handbüchern

Keine Kommentare

Seagate ST3390N Installationsanleitung Seite 459

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Seagate ST3390N