Seagate ST3390N Installationsanleitung Seite 39

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 468
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 38
Unpacking and inspecting the equipment 4-5
Removing and reinstalling printed circuit packs
Standard 1.0 Modular Option EC Installation and Maintenance Guide November 1999
Removing and reinstalling printed circuit packs
Introduction
To remove and reinstall the printed circuit packs (PCPs), follow
these steps.
Step Action
1 Open the ejectors on the card and gently pull the card toward
you until it clears the shelf.
Note:
The ejectors latch on to a pin on the card. If the ejectors
will not open, pinch them to raise them up and off the pin.
2 Check the card to make sure that it is not bent and there are no
loose parts.
3 If you are not reinstalling the card immediately, place the card in
an electrostatic discharge (ESD) protective container and place
it in a safe location.
4 Reseat the card in the module: align it with the slots in the
module with the ejectors still in the open position, and then
gently slide the card back into the module.
5 Seat and lock the card as follows:
a. Push the upper and lower edges of the faceplate to ensure
that the card is fully seated in the module.
b. Close the ejectors.
(a) (b)
G100044
Seitenansicht 38
1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 467 468

Kommentare zu diesen Handbüchern

Keine Kommentare