Seagate ST31230N/ND Installationsanleitung PDF herunterladen (Seite 189)

Starting up and configuring Meridian Mail 13-23

Checking out Meridian Mail

Standard 1.0 Option 11 EC Installation and Maintenance Guide November 1999

10 Check the status of each DSP to make sure they are

all functional. Press the [DSP Port Status] softkey.

Result: DSP Port Status should be idle for all ports.

Note: For a full description of this screen, see the

System Administration Guide

(NTP 555-7001-301).

This document also describes how to run out-of-

service diagnostics for ports that do not come to idle

status on startup or to active status during the testing

described in steps 14 to 16.

11 While watching the DSP port status screen, dial the

voice messaging DN from a phone connected to the

switch.

12 Note which channels become active.

13 Ensure there is no noise on the line.

14 Release, and repeat steps 11 to 13 until all ports

have been tested.

15 If all appears to be OK, press the [Exit] softkey to

return to the Logon screen.

16 Install and close the cover on the EC 11 cabinet.

CAUTION

Risk of equipment damage

To reduce stress on the system, use the reset

button on the faceplate of the Enhanced

MMP40 or MMP40 card to restart the system

instead of powering the cabinet off and on.

Reset node 1 first, then node 2 in sequence,

as applicable.

However, if there is a question regarding the

state of the system after the system reset,

power off the system, wait 10 seconds, then

power it back on to restart.

1 2 ... 184 185 186 187 188 189 190 191 192 193 194 ... 271 272

Keine Kommentare

Seagate ST31230N/ND Installationsanleitung Seite 189