Seagate ST31230N/ND Installationsanleitung PDF herunterladen (Seite 163)

Configuring customer options on the Option 11 switch 12-7

Configuring the trunk route data block (NMS only)

Standard 1.0 Option 11 EC Installation and Maintenance Guide November 1999

Configuring the trunk route data block (NMS only)

Configuring the trunk

route data block

This procedure shows how to configure the trunk route data

block for the Network Message Service (NMS) feature.

Note: Do not use Digit Manipulation (DMI in Overlay 86) to

insert ESN access codes at the sending switch. Insert ESN

access codes at the receiving switch (at the INAC prompt in

Overlay 16).

To configure the trunk route data block, follow these steps.

Overlay 16—Route

data block parameters

Step Action

1 Load Overlay 16 at the Meridian 1 administration

terminal.

2 Respond to the prompts as shown in the following

table—Overlay 16.

3 When the configuration is complete, enter **** or type

END followed by <RETURN> in response to the

prompt REQ.

Prompts Responses Description

REQ NEW or CHG New or change

TYPE RDB Route Data Block

CUST —— Meridian 1 customer number

ROUT —— Route number

PNI —— Customer private network ID of

non-local target Meridian 1

NCRD YES Network call redirection will

provide the CLID display

information.

TRO YES Optimize trunk usage on this route.

INAC YES Insert ESN access code to

incoming private network call.

<cr>

Press carriage return to the end of

the overlay. (The prompt REQ

comes up.)

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 271 272

Keine Kommentare

Seagate ST31230N/ND Installationsanleitung Seite 163