Seagate ST1.2 Series Spezifikationen PDF herunterladen (Seite 9)

ST1

M/ST1

Controller Installation Guide, Rev. E

1.2 Controller Physical Installation

CAUTION: VERIFY THAT THE POWER IS OFF.

Remove the System Cover (Refer to your system manual).

Access to the screws is usually at the back of the system. Save the

screws. Systems vary, but most require you to slide the cover foward

for removal.

Install the Controller as Illustrated in Figure 4.

Verify that all connections are correct and replace the system cover

Optional Drive Power Connector on the ST1

M/ST1

Normally, drive power is supplied via a power harness

from

the

system power supply directly to the drive’s J3 DC power connector.

The J5 connector on the ST1 1

M/ST1

can be used to provide disc

drive power in systems lacking an extra power harness or for

Drive-on-a-Cardapplications. See connector J5, Figure 3.

A cable splitter, often called a Y-cable, may be used to tap off the

diskette drive power cable. They are available from most Dis-

tributors/Dealers.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Seagate ST1.2 Series Spezifikationen Seite 9