Seagate ST1.2 Series Spezifikationen PDF herunterladen (Seite 15)

ST1 1

M/ST1

Controller Installation Guide, Rev. E

To access the controller’s format routine; at the

“-”

prompt type:

G=XXXX:5 (Where XXXX is correct address, Refer to Fig 3.)

Note:

Seagate

controllers will

step you through the process. Refer

to the drive charts Figures l-2 for correct drive parameters.

On drives over than 32 formatted megabytes, DISK MANAGER will

automatically partition and high-level format the drive.

Use FDISK and FORMAT on your DOS diskette for drives less than

32 formatted megabytes.

5.0 Troubleshooting Your Installation

If you have a problem getting the initial screen, or later getting the system

to boot:

Check the cabling between the controller and drive. Pin-l on the

controller always corresponds to Pin-l at the drive connector. Most

cables have a contrasting color on the cable to indicate Pin-l.

Check the power cable to the drive. Can you hear the drive spinning

up?

Verify correct Drive Select number.

Verify correct BIOS address for the controller. See page 6. If you

have more than one board that uses BIOS ROM space, each must

be configured to a different memory address. Addressing multiple

boards at the same memory location can cause problems of a

seemingly indeterminate nature.

Low-level formatting takes too long or never completes.

Format again. Make sure correct drive parameters were entered and

cable connections are correct.

FDISK or Partitioning Error Messages: “Error reading fixed disc” “No

fixed disc present”

1 2 ... 10 11 12 13 14 15 16

Keine Kommentare

Seagate ST1.2 Series Spezifikationen Seite 15