Seagate ST1.2 Series Spezifikationen PDF herunterladen (Seite 14)

ST1 1

M/ST1

Controller Installation Guide, Rev. E

4.0 Non-Paired Drive Formatting

Use this procedure for non-paired drives or when reformatting a paired

drive whose installation software files were lost or not copied before

formatting.

Be sure to back up any drive containing data. Formatting at any level

may result in partial or complete loss of data.

Seagate

Technology, Inc.

assumes no liability for lost data.

If you use the DOS DEBUG utility to low-level/primary format the drive,

you must answer “YES” to the question, “Do you want to enter the defect

map which is supplied on your hard disc drive cover”. Proceed with

entering all defects from the defect map.

Important Note:

If you use the ST1 1

M/ST1

controller, BIOS Version

2.0, with a

Seagate

Paired Program drive, but do not use the

Seagate

installation software (INSTALLR), you must manually enter the

Manufacturer’s Defect Map (attached to the drive top cover) during the

low-level/primary formatting operation.

Always use the same version of DOS throughout the entire process. On

two-drive systems: Always use the same version of DOS on both drives.

When adding a second drive, it is sometimes necessary to reformat the

first drive.

4.1 Low-Level Physical Format Using BIOS Facility

When using DEBUG to format in a AT system, the CMOS or system

setup should be set to 0 (i.e., no hard drive installed).

Boot the system from the DOS system diskette

At the A: prompt, insert the DEBUG diskette and type:

DEBUG

<ENTER>

1 2 ... 9 10 11 12 13 14 15 16

Keine Kommentare

Seagate ST1.2 Series Spezifikationen Seite 14