Seagate ST1.2 Series Spezifikationen PDF herunterladen (Seite 16)

ST1 1

M/ST1

Controller Installation Guide, Rev. E

Check correct drive parameters entered. Refer to pages 3-4. Turn

the system off and power-up again. Rerun FDISK.

High-Level Format Error Message: “Invalid drive specification”

Run FDISK again to make sure the DOS partition is active. Check

drive parameters and low-level format again. Check controller

jumpers.

In AT systems, check that no drive type is entered in the system

CMOS setup for the drive attached to the ST1 1

M/ST1

Drive fails to recalibrate or test Ready.

Check installation, cables and drive select jumper.

I/O error messages when using DISK MANAGER:

“Uncorrectable ECC

I/O Error”

“Unrecoverable I/O Error”

If you are formatting a drive in an XT or using the ST1 1

M/ST1

controller in an AT, low-level format the drive through DEBUG using

the controller’s BIOS routine.

After formatting with DISK MANAGER, your system does

not recog-

nize the D, E, F... partitions:

First, make sure that you boot from the hard drive. If you still cannot

access these partitions, check that the DISK MANAGER device

driver, DMDRVR.BIN is in the root directory of the C: (boot) drive.

Verify that the CONFIG.SYS file contains the following line:

DEVICE

DMDRVR.BIN

If you experience problems accessing your DOS partition after installa-

tion, refer to the help files provided with DISK MANAGER.

For system or DOS help, contact your computer system manufacturer.

For additional installation help, contact your authorized

Seagate Dis-

tributor/Dealer.

1 2 ... 11 12 13 14 15 16

Keine Kommentare

Seagate ST1.2 Series Spezifikationen Seite 16