Seagate ST1.2 Series Spezifikationen PDF herunterladen (Seite 11)

ST1 1

M/ST1

Controller Installation Guide, Rev. E

2.0 Preparing to Format Your Drive

Please read this section before proceeding to the formatting in-

structions. Be sure to back up any drive containing data. Formatting

at any level may result in partial or complete loss of data.

Seagate

Technology, Inc. assumes no liability for lost data.

Always use the same version of DOS throughout the entire process.

On two-drive systems: Always use the same version of DOS on both

drives. When adding a second drive, it is sometimes necessary to

reformat the first drive.

DOS assigns a logical identifier (C, D, E . ..) to each partition that it

recognizes during the boot load. It assigns these letters to the first

partition on each physical drive in sequential order (e.g., C to Drive

D to Drive 2. Subsequent letters are assigned to the remaining

partitions on Drive 1, followed by Drive 2. See table below for typical

examples:

For optimum performance, format the drive installed in your system

in the same orientation in which it will be used.

2.1 Paired Program Drive Formatting

Paired Program drives are shipped with a small DOS partition containing

Installation software and a

README

file which has the latest information

for the drive being installed. See Section 3.0.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Seagate ST1.2 Series Spezifikationen Seite 11