Seagate ST3250824NS Anleitung zur Fehlerbehebung PDF herunterladen (Seite 32)

32 R/Evolution 2730 Release Notes for Software Version J200R05 • October 2007

■ 5030: Help for the Verify Virtual Disk page incorrectly says to click the

Verify & Update Virtual Disk Parity button, but the button's correct name is

Verify Virtual Disk Parity.

■ 5035: Data corruption can occur upon a failover on SPARC Solaris 10 with

Emulex HBAs and a Qlogic 5600 switch. The cause is redriving write I/Os to a

switch port in which the WWNN of the target has changed due to the failover.

The GPN_ID responses to the Sun box (after RSCN from the switch) report a

new target (WWNN) as does the PLOGI response on re-login. However, the

writes that are driven down this port are to the old target which causes corruption

on all the LUNs. This occurs if the new target comes back up within the 4

GPN_ID retries that Solaris issues. If all four of these timeout, the host attempts

a switch discovery process (GA_NXT sequences) and reroutes the pending I/Os

correctly. A bug has been filed with Sun CR 6605700.

■ 5040: While running the array at 35C ambient 50% humidity in an

environmental chamber, the

show enclosure-status command indicates

Temp 01 as "Critical" at 51C. However, the

show sensor-status

command reports the Upper-Ctlr A Temperature at 51C as a "Warning."

■ 5049: show snap-pools will return incorrect data when “base 2” is

selected. Workaround: Ensure base 10 format is used when viewing snapshot

information. For example:

■ 5051: When a controller is shut down via the WBI, the Host Port

Configuration page does not display the link speed option 4 GBit/Second.

Only the 2 GBit/Second option is displayed.

■ 5065: Controllers became unresponsive after the following CLI command

was issued while running an automated test script:

Workaround: Restart the controllers.

■ 5088: Volume copy to a master volume which is larger than the snap pool

will result in a restart of the system (both controllers).

# set cli-parameters base 10

# delete master-volume “mastervolume-10”

1 2 ... 27 28 29 30 31 32

Keine Kommentare

Seagate ST3250824NS Anleitung zur Fehlerbehebung Seite 32