Seagate ST3250824NS Anleitung zur Fehlerbehebung PDF herunterladen (Seite 23)

Release Notes 23

Solaris 10 Operating System HBA Support

Fibre Channel HBAs you can use with Solaris 10 are shown below.

The Solaris 10 operating system includes

fp and fcp drivers, which each have a

timeout setting. The default for

fcp_offline_delay is 20 seconds. To avoid

certain filesystem warning messages when a cable is removed or a controller is

killed or shut down, you can change the timeout setting to 60 seconds by changing

this line on Solaris 9 hosts in

/kernel/drv/fcp.conf:

fcp_offline_delay=60;

Note – One reboot of the host is necessary for this parameter to take effect.

In addition, Sun Microsystems has provided a patch for both x86 and SPARC

platform editions of the Solaris 10 operating system that fixes the

fcp_offline_delay parameter issue. These patches are required with Solaris 10

Update 1 or Solaris 10 Update 2:

■ Solaris 10 SPARC Platform Edition: 119130-32

■ Solaris 10 x86 Platform Edition: 119131-32

Note – Solaris 10 Update 3 includes the fcp_offline_delay parameter fix and

does not require the patch.

Fibre Channel HBAs you can use with Solaris 9 are shown below.

Table 9 Solaris 10-Supported HBAs

HBA Driver

Emulex LP 11002 Solaris 10 Update 1 or later includes the needed driver

Qlogic QLA2462 Solaris 10 Update 1 or later includes the needed driver

Table 10 Solaris 9-Supported HBAs

HBA Driver

Emulex LP 11002 Sun SAN Foundation Suite 4.4.12 or later includes the needed

driver

Qlogic QLA2462 Sun SAN Foundation Suite 4.4.12 or later includes the needed

driver

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Keine Kommentare

Seagate ST3250824NS Anleitung zur Fehlerbehebung Seite 23