Seagate ST3250824NS Anleitung zur Fehlerbehebung PDF herunterladen (Seite 16)

16 R/Evolution 2730 Release Notes for Software Version J200R05 • October 2007

10. If you are not able to ping the controller, you need to restart the Management

Controllers.

a. Type the following command:

b. Confirm by typing Y.

c. Enter the

ping command again.

11. Exit the emulator and disconnect from the CLI.

12. Log in to RAIDar on controller A as a Manage user with the correct password.

The login page is displayed. Continue with “Completing the Upgrade”.

Completing the Upgrade

1. Select Monitor > Advanced Settings > Controller Versions and verify that all

software components have been upgraded on both controllers.

2. Select Manage > General Config > LAN Configuration and verify that the LAN

information has not changed.

3. If you were using DHCP prior to the upgrade, reset Source For IP Address to

DHCP.

4. Enable the Partner Firmware Upgrade (PFU) feature.

a. Select Manage > General Config > System Configuration.

b. Set Partner Firmware Upgrade to Enable.

c. Click Change System Configuration.

When processing is complete, a message near the top of the page informs you

that your change was successful.

5. Resume host I/O.

restart mc both

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Keine Kommentare

Seagate ST3250824NS Anleitung zur Fehlerbehebung Seite 16