Seagate ST34572WC Spezifikationen PDF herunterladen (Seite 21)

groups were configured with only persistent device special files, there is no need to arrange them

again.

On releases prior to HP-UX 11i v3, you must rebuild the lvmtab file as follows:

# vgreduce -f vgname

# mv /etc/lvmtab /etc/lvmtab.save

# vgscan –v

Note : Starting with 11i v3, use the following steps to rebuild the LVM configuration files

(/etc/lvmtab or /etc/lvmtab_p):

#vgreduce –f vgname

#vgscan –f vgname

In cases where the physical volume is not readable (for example, when the physical volume is

unattached either because the disk failed before volume group activation or because the system has

been rebooted after the disk failure), running the vgreduce command with the -f option on those

physical volumes removes them from the volume group, provided no logical volumes have extents

mapped on that disk. Otherwise, if the unattached physical volume is not free,- vgreduce -f reports

an extent map to identify the associated logical volumes. You must free all physical extents using

lvreduce or lvremove before you can remove the physical volume with the vgreduce command.

This completes the procedure for removing the disk from your LVM configuration. If the disk hardware

allows it, you can remove it physically from the system. Otherwise, physically remove it at the next

scheduled system reboot.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 66 67

Keine Kommentare

Seagate ST34572WC Spezifikationen Seite 21