Seagate ST31276A Spezifikationen PDF herunterladen (Seite 10)

ST3144 Family Installation Guide, Rev. D

Frame kit and remote LED

To install this 3.5inch drive in a 5.25inch frame, use a

Seagate

frame kit, part number 54459-016. This

frame

kit can only be used

with drives that have standard-size mounting holes. These drives

have an “S” stamped on each frame runner. If your drive has an

“M” (for metric) stamped on each frame runner, do not attempt

to mount it in this frame kit.) The frame kit contains a remote LED.

Installation trouble-shooting

Before you begin trouble-shooting, read and be aware of all the

considerations discussed in this section. The suggestions pre-

sented here resolve the vast majority of installation problems.

Warning. Always power down the system before changing

jumper settings or unplugging cables and cards.

Verify compatibility. Check the documentation for the host

adapter and the drive to confirm that these components are

appropriately matched for each other and to your system.

Verify your configuration. Refer to the drive and controller

installation guides to make sure all jumper settings suit your

configuration requirements.

Check all cables. Make sure all cables are securely con-

nected. Ribbon cables are especially fragile. Make sure they

are not crimped or damaged in any way. Having extra cables

on hand for trouble-shooting saves time and frustration.

Note. Most cables have a stripe on one side to designate the

Pin 1 location. Make sure Pin 1 on the interface cable connec-

tor is connected to Pin 1 on the drive interface connector and

Pin 1 on the host connector. Refer to Figure 1 for the location

of Pin 1 on the drive interface connector.

1 2 ... 5 6 7 8 9 10 11

Keine Kommentare

Seagate ST31276A Spezifikationen Seite 10