Seagate ST11200N Technical Information PDF herunterladen (Seite 58)

Configuring Tape Drives

To use density setting 1, use the following no rewind on close device file:

/dev/rmt*.1

To use density setting 2, use the following no rewind on close device file:

/dev/rmt*.5

Adding Sony AIT Drives

Sony S-AIT drives have dip switches (SWA and SWB) located on the bottom of the drive.

It is important that these switches are set correctly for use in an SSO configuration.

Depending on the serial number of the drive, S-AIT drives are shipped from Sony with

one of two switch settings for SWA-1 of SWA.

If your drive has an early serial number, it may have SWA-1 (No Reply Unit Attention

After Process Login) set to Off. In this case, you must change the setting to On.

Drives with newer serial numbers have SWA-1 set to On as the default, as shown in the

following table (1 = On and 0 = Off). These newer serial numbers are SDZ-130 :01442007

or SDZ-130/L :01200696 and later models, and a date of May 17, 2004.

Switch Setting

SWA-1 1

SWA-2 0

SWA-3 0

SWA-4 0

SWA-5 0

SWA-6 0

SWA-7 1

SWA-8 0

44 NetBackup Media Manager Device Configuration Guide for UNIX, Windows, and Linux

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 112 113

Keine Kommentare

Seagate ST11200N Technical Information Seite 58