Seagate ST12550WD Betriebsanweisung PDF herunterladen (Seite 50)

Release Notes

EK-KZPSA-RN. A01 Page 3

Mandatory Console Code Update

During the qualification testing of the KZPSA, some critical problems were found with the console code for the

AlphaServer systems. You need to update your systems with the new code provided on the diskettes included with

this option.

If you have an AlphaServer 1000, locate diskette AK-QK57A-CA from the option package. The procedure to be

followed is from the AlphaServer 1000 Owner’s Guide, Order Number: EK-DTLSV-OG.A01, (page 7-5) entitled

"Updating Firmware Using the Diskette Drive". The steps are as follows:

Insert the diskette with the new firmware version in the diskette drive.

1. Enter the following command at the SRM console prompt:

>>> boot dva0

2. Load and execute the update utility:

APU-> update

3. Turn the system off and on.

4. Confirm the update:

>>> show version

This should report the revisions for SRM as X3.10-3798 and ARC as 4.1-19. The update has successfully com-

pleted. OK to proceed! If you have not completed successfully, please refer to your AlphaServer 1000 Owner’s

Guide.

If you have an AlphaServer 2000 or 2100, locate diskette AK-QK58A-CA from the option package. The proce-

dure to be followed is from the AlphaServer 2x00 Loadable Firmware Update Utility User Guide and Release

Notes that came with your system. The procedure starts on page 4-3 with "Booting the Update Utility from the

OpenVMS Diskette". The steps are as follows:

First, insert the firmware update diskette into the system diskette drive and boot the diskette, as shown in the fol-

lowing example:

>>> boot dva0 # NOTE: No colon on DVA0, please

This takes about 2 minutes...

After several minutes the Loadable Firmware Utility menu and prompt “UPD>“ should appear on the VGA (or a

serial line terminal on COM1). If the update utility has booted successfully, then skip to chapter 5.

Continuing at paragraph 5.1, Steps to Update the SRM and ARC Console Firmware

NOTE

The update command under the LFU updates both the SRM

and ARC console.

1. At the LFU prompt, UPD>, type update or update*

UPD> update

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 66 67

Keine Kommentare

Seagate ST12550WD Betriebsanweisung Seite 50