Seagate ST12550WD Betriebsanweisung PDF herunterladen (Seite 47)

Chapter 7. Troubleshooting

EK–KZPSA–UG. B01 7–5

7.4 Boot Sequence Problems

Table 7–3 describes possible problems during the boot sequence, specifies their

probable cause, and suggests corrective actions.

Table 7–3 Boot Sequence Troubleshooting Table

Symptom Probable Cause Corrective Action

Boot failure Incorrect boot device

was specified.

Redefine the default boot device at the

SRM console as described in Section 4.7

of this guide.

Note: Booting "Windows NT"

through the KZPSA adapter is not sup-

ported.

KZPSA is not terminated

properly.

Ensure each end of the SCSI bus is termi-

nated.

KZPSA is in an unknown

state.

Initialize the adapter by either entering the

SRM console “init” command or press the

system reset button.

Device not

recognized

during boot.

KZPSA is not terminated

properly.

Ensure each end of the SCSI bus is termi-

nated.

Operating system not

configured correctly.

Reconfigure system software. Refer to

system documentation.

Operating system does

not contain device driver

or driver not installed

correctly.

If running Windows NT, ensure the device

driver is installed. If running OSF/1, ensure

that the OS revision level supports the

KZPSA.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 66 67

Keine Kommentare

Seagate ST12550WD Betriebsanweisung Seite 47