Seagate ST200FP0021 Spezifikationen PDF herunterladen (Seite 13)

Connections Continued

• PTZ Cameras

Connect the RS-232 or RS-485 connector to the PTZ camera(s) via the appropriate cable. The

DVR supports a variety of different PTZ cameras, including any camera that supports the

Pelco D protocol (all Channel Vision PTZ cameras), Samsung SCC-641P, Kalatel Cyber Domes,

Bosch AutoDome cameras, etc. Different PTZ cameras can only coexist in the same system if

they all support and use the same protocol. Set the PTZ ID and protocol in the DVR, and then

connect the PTZ camera directly to the DVR via RS-232 or RS-485.

For more information on setting up PTZ cameras, refer to pages 46 & 59.

• RS-485 Keyboard or Terminal:

Connect the RS-485 connector to a RS-485 keyboard or the VT-100 terminal using the

appropriate cables. Verify the RS-422/485 configurations as described on page 46.

• eSATA Hard Disk:

Connect the eSATA connector to an eSATA HDD. To use more than one eSATA HDD, connect

the internal SATA cable to SATA #6 connector on the DVR board, (16 channel model) or

SATA # 2 (4 and 8 channel model). A DVD burner cannot be used if the eSATA feature is used.

The DVR circuit board is labeled with each connector number.

• GPS Modem:

Connect the RS-232 connector to a GPS modem via the appropriate cable. This DVR supports

GPS modems that use the NMEA0183 protocol. The RS-232 port must be set up according to

the instructions on pages 46-49.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 85 86

Keine Kommentare

Seagate ST200FP0021 Spezifikationen Seite 13