Seagate Elite 9 Installationsanleitung PDF herunterladen (Seite 27)

Elite 9 Installation Guide, Rev. B 25

Write Protect

Reserved

J4A

DC Power

Connector

J4A

SCSI I/O

Connector

J4B

J01

Spinup delay equal to the SCSI bus ID multiplied by 10 seconds.

Valid only if the Start Command jumper is disconnected.

J4B

Spinup Delay Option

Pin 1

Immediate spinup. Valid only if the Start Command 

Option jumper is disconnected. (factory setting)

Start spindle after the SCSI bus sends a Start Unit command.

Start Command Option

Start spindle according to the Spinup Delay Option jumper. 

(factory setting)

Ignore parity check.

SCSI Bus Parity Check

Check the parity of data bytes read from the 

SCSI bus. (factory setting)

Reserved.

Write Enable (factory setting)

Pin 1

Active LED connector (+)

Ready LED connector (+)

Fault LED connector (+)

Ground (–)

LED Connections

Connect the anode to the desired LED 

connector and the cathode to the ground pin.

Figure 7. Additional jumper options

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Keine Kommentare

Seagate Elite 9 Installationsanleitung Seite 27