Configuring Primary and Secondary Disks
102 NetBackup ServerFree Agent System Administrator’s Guide
HORCM_CMD
Enter values for the following:
◆ cmd_dev_file: the command device file(s) for the array. For example,
/dev/rdsk/c2t8d14s2.
You can use the NetBackup bptpcinfo command to determine the command device
file, as follows:
bptpcinfo -d /dev/rdsk -o- | grep CM
Below is sample output showing a command device file for an Hitachi device and for
an HP device.
The format of the output is:
p=/dev/rdsk/c#t#d#s2 s=VID:PID:SN
where:
- VID (vendor ID) must be HP or HITACHI.
- PID (product ID) must include -CM.
- The first five characters of the serial number (SN) must match the serial number
of the disks.
In this example, the command device file for the Hitachi array is
/dev/rdsk/c2t8d14s2 and for the HP array it is /dev/rdsk/c2t5d35s2.
HORCM_DEV
Enter values for the following:
◆ dev_group: a user-defined name of a logical grouping of primary and secondary
disks.
◆ dev_name: a user-defined name assigned to a primary-secondary pair of disks within
the logical group.
The dev_group and dev_name parameters are used on the “pair” configuration
commands described later in this section.
◆ port #: the port number specified for the disk, configured by means of the array’s
dedicated console (not from a NetBackup host).
p=/dev/rdsk/c2t8d14s2 s=HITACHI:OPEN-9-CM:60159001C00
p=/dev/rdsk/c2t5d35s2 s=HP:OPEN-3-CM:30436002500
Command
device files
(note “CM”):
Kommentare zu diesen Handbüchern