Seagate ST32550WC Bedienungsanleitung PDF herunterladen (Seite 7)

Trouble Shooting Information

Problem Possible Solution

System fails to boot General: Check power. Check cabling, connectors and socketed

components are properly seated. Remove all components except

minimal memory and a processor and reboot. If possible check

individual components (especially processors and memory) in a

known good system.

1. Check for processor termination card in empty 242 contact slot

connector.

2. Check for approved memory DIMM modules.

3. Check to assure that the power supply connector is correctly

attached to the L440GX+ 24 pin (ATX 20pin +4) power

connector. The Intel Astor II Server Chassis uses a 24 pin

“Modified ATX” power connector, but the Intel Columbus III

Server Chassis and most third party chassis use 20 pin ATX

power connectors. In the case of an ATX 20 pin power connector,

it plugs into the first 20 pins of the L440GX+ 24 pin power

connector, closest to the center of the server board. Refer to the

printed L440GX+ “Quick Start Guide” or the Electronic

L440GX+ Product Guide also available on the CD that ships with

the product. For further information, both of these documents are

also available on the Intel Customer Support Website (see URL

below).

4. Ensure the Power Supply is providing at least 800mA of +5V

standby current to support WOL,* if not, disable WOL via the

WOL Enable jumper on the server board (J5A2).

System will not boot from

the L440GX+ Server

Board Resource CDROM

Incorrect BIOS Boot priority order. Press <F2> during the server’s

POST and configure in BIOS set-up.

EMP Console unable to

connect with the

L440GX+ based server

system

Ensure Service Pack 3 was re-installed after installation of EMP

Console utility if using Windows NT 4.0 Workstation.

Other For further support information, check

http://support.intel.com/support/motherboards/server/l440gx

1 2 3 4 5 6 7

Keine Kommentare

Seagate ST32550WC Bedienungsanleitung Seite 7