Seagate ST118273WC Betriebsanweisung PDF herunterladen (Seite 64)

Configuring a Tape Drive

5-2 Peripherals Configuration (R1001H) HP-UX version 11.00.01

When configuring a tape drive, have available the following additional

documentation:

■ Continuum 600 and 1200 Series: Tape-Drive Operation Guide (R442), HP-UX

Operating System: Continuum Series 400 Hardware Installation Guide (R002H),

HP-UX Operating System: Continuum Series 400-CO Hardware Installation

Guide (R021H), or other appropriate installation guide

■ HP-UX Operating System: Fault Tolerant System Administration (R1004H)

■ the online man pages

Tape drives can be configured using either SAM or the command-line interface.

Configuring a Tape Drive

The simplest way to configure a tape drive is to use SAM. If SAM is not loaded on

your system or if you prefer to use the command-line interface, the following

procedure will guide you through the task. You should understand the

instructions before getting started. Instructions on using SAM can be found in the

HP-UX Operating System: Fault Tolerant System Administration (R1004H) and the

Managing Systems and Workgroups (B2355-90157).

1. Log in as root.

2. Check what SCSI addresses are available (that is, what addresses have not yet

been used) on the external SCSI port to which you are attaching the tape drive.

To do this, enter

ftsmaint ls

Check for SCSI addresses used at LSM locations. The new tape drive can use

any unused legal (0–5; 5 recommended) SCSI address. Figure 5-1 shows

sample ftsmaint output.

Figure 5-1. Sample Continuum System ftsmaint output, LSM portion

Modelx H/W Path Description State Serial# PRev Status FCode Fct

================================================================================

- 14 LSM Nexus CLAIM - - Online - 0

- 14/0/0 LSM Adapter CLAIM - - Online - 0

- 14/0/0.0 CLAIM - - Online - 0

d80200 14/0/0.0.0 SEAGATE ST32550W CLAIM - - Online - 0

- 14/0/0.1 CLAIM - - Online - 0

d80330 14/0/0.1.0 SEAGATE ST34573WC CLAIM - - Online - 0

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 85 86

Keine Kommentare

Seagate ST118273WC Betriebsanweisung Seite 64