Seagate ST9235 Family Installationsanleitung

. . . . . . . . . . . . . . . . . . . . . . . . . .ST9235 Family:. . . . . . . . . . . . . . . . . . . . . . . . . .ST9080A. . . . . . . . . . . . . .

your system BIOS may look for 4 bytes of ECC. If your systemBIOS expects 4 bytes of ECC and the drive supplies a differentnumber of bytes, some dr

High-level formattingOnce the drive is partitioned, use the DOS FORMAT command(or equivalent utility program) to high-level format each of thedrive pa

location. Make sure pin 1 on the interface cable connector isconnected to pin 1 on the drive interface connector and pin 1on the host connector. Refer

Appendix A.AT interface connector pin assignmentsReset–GroundDD7DD8DD6DD9DD5DD10DD4DD11DD3DD12DD2DD13DD1DD14DD0DD15Ground(removed)DMARQGroundDIOW–Grou

Appendix B.Mounting dimension drawings4X 3 mm × 0.5 mm0.15 in (3.81 mm)min. full thread1.375 ± 0.015(34.93 ± 0.38)0.066 ± 0.020(1.68 ± 0.51)0.100 ± 0.

0.157 ± 0.020(3.99 ± 0.51)0.146 +0.011, –0.008(3.71 +0.28, –0.20)4X 3 mm × 0.5 mm,0.15 in (3.81 mm)min full thread0.0002.590 (65.79)0.0004.010 max (1

Key to mounting specifications:non-MCC mountMCC mount0.750 (19.05) max4X 3 mm × 0.5 mm0.15 in. (3.81 mm)min. full thread1.375 ± 0.015(34.93 ± 0.38)0.0

Appendix C.Technical support servicesProduct technical support is available for all Seagate products bycalling the SeaFAX, SeaFONE, SeaTDD and SeaBOAR

• A directory of information and helpful utility programs thatyou can download to your own computer.• The FINDTYPE.EXE utility program, which can be v

ContentsRead before you begin... . . . . . . . . . . . . . . 1Installation overview . . . . . . . . . . . . . . . . .

Seagate Technology, Inc.920 Disc Drive, Scotts Valley, CA 95066, USAPublication Number: 36216-001, Rev. B, Printed in USA

Read before you begin...Note. Drives in the ST9235 family are usually installed in note-book or laptop systems. Special training or tools may beneede

Warranty. Contact your authorized Seagate distributor or dealerfor warranty information.Maintenance and repair. Seagate drives do not require an

Setting master/slave jumpersTwo drives may be controlled through a single drive controllercable with two connectors. In this case, one drive is design

Master/slaveconfiguration jumpersCircuit boardPin 1Pin 20 removed for keyingDrive is master; no slave presentDrive is master; Seagate slave drive pres

Mounting the driveYou can mount (and operate) a ST9235 family drive in anyorientation. However, you must securely attach the drive to a rigidfr

drive types your BIOS supports. Another method is to run theFINDTYPE.EXE utility program, available from Seagate Techni-cal Support services (on the S

table above. This value will be lower than the usable drivecapacity.In a few situations, none of the drive types specified in your BIOSsetup